ASSEMBLY INSTRUCTIONS

INSTALL THE SHOULDER HARNESS LOOP

When operating the brushcutter attachment, you must use the shoulder harness that is provided with the unit.

Check to see if your trimmer has a wire form support fitting that you can clip the strap to. If your unit has the fitting that is shown in Figure 4, you do not need to install the harness loop provided. If so, head to the next section Install the Harness.

Wire Form

Support Fitting

Fig. 4

If your trimmer does not have an existing wire form fitting, you must install the clip that is included with the TBBC.

To install the supplied shoulder harness clip:

1.Remove the bolt, nut and washer that were installed on the harness loop for shipping. Keep them handy.

2.Pull the clamp open and push it onto the boom.

3.Arrange the clip so that it is close to the shaft grip and away from the J-handle (Fig. 5).

4.Insert the bolt through the clip and secure it with the washer and nut, using a pair of pliers and a small crescent wrench.

Boom

J-handle

Shaft

Grip

Securing

Nut

INSTALL THE SHOULDER HARNESS

WARNING: Always use the shoulder harness

when using the cutting blade to avoid serious personal injury.

1.Push the strap through the center of the buckle.

2.Pull the strap over the cross bar and down through the slot in the buckle (Fig. 6).

3.Put the harness on over head and onto the left shoulder. Snap it on to the support fitting (Fig. 7).

4.Adjust length to fit the operator’s size. Pull tab to lengthen, pull strap to shorten (Fig 8).

Fig. 6

Fig. 7

Fig. 5

Fig. 8

9