True Food Service Equipment, Inc.
INSTALLATION / OPERATION INSTRUCTIONS
•Phillips screw driver
•3/8” (9.5 mm) socket or 3/8” (9.5 mm) wrench
Step 2
A.Use a Phillips screw diver and remove four screws from the
To avoid damage to glass DO NOT lay cabinet on its side or back when removing skid, installing leg levelers, cleaning, etc.
B.Lift up from the base and walk unit off the skid and set in final location.
1
Removing bracket from skid.
2
C.Unblock doors, (free plastic wedges, blue foam and tape. Remove fiberglass tape securing glass. Remove components: (shelves, brackets, etc.) from inside cabinet.
Removing bracket from cabinet.
Step 3
A.Set unit in its final location. Be sure there is adequate ventilation in your room. Under extreme heat conditions, (100°F+, 38°C+), you may want to install an exhaust fan.
Warning
B.Proper leveling of your True unit is critical to operating success (for
Warning
Display case must be leveled accurately to ensure front glass door seals properly.
C.The unit should be leveled front to back and side to side with a level. Place the level in the interior floor of the unit and check all four sides.
D.If the cabinet is not level adjust leg levelers by first relieving weight to leveler and adjusting by either hand or wrench. Repeat with all leg levelers until cabinet is level in all directions.
E.Ensure that the drain hose or hoses are positioned in the pan.
F.Models with power cord: Free plug and cord from inside the lower rear of the cooler (do not plug in).
G.Models with power cord: The unit should be placed close enough to the electrical supply so that extension cords are never used.
Warning
Compressor warranties are void if the unit is more than 9 ft. (3 m) from
5 | www.truemfg.com | 5 |