True Manufacturing Company TCGR-50 Temperature Control Adjustment For High Altitude Only, Terms

True Food Service Equipment, Inc.

MAINTENANCE, CARE & CLEANING

TEMPERATURE CONTROL ADJUSTMENT FOR HIGH ALTITUDE ONLY!

TERMS:		NOTE
•	Cut-out - Temperature sensed by the controller	Mechanical temperature controllers are affected
	that shuts the compressor off.	when functioning at high altitude. The Cut-in and
•	Cut-in - Temperature sensed by the controller	cut-out temperatures will be colder than when the
		controller functions closer to sea level.
	that turns the compressor on.
TOOLS REQUIRED:		D. For high elevation installations, it may be
		necessary to "warm-up" the set points. To
•	Phillips head screwdriver	make the adjustment, insert the appropriate
•	5/64" or 2 mm Allen wrench	tool in each adjustment screw and turn 1/4
• T-7 Torx wrench
		of a revolution clockwise (to the right). This
A. Unplug or disconnect power to the cabinet.		procedure will adjust both the cut-in and cut-
		out about 2°F warmer.
B. Remove the screws that secure the
		E. Make sure to reconnect the wire to proper
	temperature control to the inset box, lower	spade terminal when reinstalling.

right, rear of cabinet.

C.Pull out gently from cabinet.

DANFOSS TEMPERATURE CONTROL

Compressor

Connection

4

3

Cut-out Adjustment Screw Allen (5/64" or 2 mm) (clockwise for warmer)

Cut-in Adjustment Screw Torx (T-7)

(clockwise for warmer)

Compressor Connection (double terminal)

15 www.truemfg.com 15