True Food Service Equipment, Inc.
INSTALLATION / OPERATION INSTRUCTIONS
STARTUP
Step 6
A.The compressor is ready to operate. Plug in the cooler.
B.Temperature control set at No. 4 position gives freezers an approximate temperature of
C.Excessive tampering with the control could lead to service difficulties. Should it ever become necessary to replace temperature control, be sure it is ordered from your True dealer or recommended service agent.
D.Good air flow in your True unit is critical. Be careful to load product so that it neither presses against the back wall, nor comes within four inches of the evaporator housing. Refrigerated air off the coil must circulate down the back wall.
NOTE
If the freezer is disconnected or shut off, wait five minutes before starting again.
RECOMMENDATION
Before loading product we recommend you run your True unit empty for two to three days. This allows you to be sure electrical wiring and installation are correct and no shipping damage has occurred. Remember, our factory warranty does not cover product loss!
REPLACEMENT PARTS
TRUE maintains a record of the cabinet serial number for your freezer. If at any time during the life of your cooler, a part is needed, you may obtain this part by furnishing the model number and serial number to the company from whom you purchased the cooler. Call
Defrost Time Periods:
Smaller freezer Worktop and Undercounter units have an automatic defrost. As soon as the unit is plugged into a power source a defrost will automaticly start in eight hours. A defrost period will occur every eight hours after connecting to power source. Larger Worktop & Undercounter freezers have a different defrost timer. See instructions on the next page for operation information.
7 | www.truemfg.com | 7 |
