Tunturi R60 owner manual Maintenance, Malfunctions, Technical Specifications

machine and lift the device to an upright position so that it is supported by the front end support legs.

Store the rowing machine in the storage position against a wall in such a way that the front frame cannot fall on anyone by accident.

IMPORTANT! The device is shipped with a loop and a hook for securing the rowing machine properly in the storage position. Choose an appropriate storage site for your rowing machine next to a wall and attach the hook tightly to the wall at the right height. Lift the rowing machine to the storage position in front of the hook. Thread the loop provided with the rowing machine around the cross bar and attach the loop to the hook. Do not climb on the rowing machine when it is in storage position!

MAINTENANCE

•The R60 requires very little maintenance. Check, however, from time to time that all screws and nuts are tight.

•Clean the cycle with a damp cloth. Do not use solvents.

•Never remove the protective covers.

•Clean the inner surfaces of the rail if necessary so that the seat moves as smoothly and quietly as possible. If necessary, you may improve the seat movement by adding paraffin to the surface of the rails.

BATTERY REPLACEMENT

Meter batteries: A warning display reports when the batteries of the meter need to be replaced. Turn the meter carefully outward from the front frame so that you can remove the battery box cover on the back of the meter. Open the battery box cover carefully from its lower edge. Be careful not to damage the wires. Replace the batteries (4 “C” batteries) in the battery box according to the markings. Replace the cover.

Pull-bar battery: If the pull-bar controls cease to respond completely, replace the battery

O W N E R ' S M A N U A L • R 6 0 G B

(3V lithium cell CR2032). Open the cover of the battery box on the back of the pull bar by removing the attachment screw. Replace the battery; make sure you place it in the right direction inside the holder. Replace the cover.

MALFUNCTIONS

Despite continuous quality control, defects and malfunctions caused by individual components may occur in the equipment. In most cases it’s unnecessary to take the whole device in for repair, as it’s usually sufficient to replace the defective part.

If the equipment does not function properly during use, contact your Tunturi dealer immediately. Always give the model and serial number of your equipment. Please state also the nature of the problem, conditions of use and purchase date.

If you require spare parts, always give the model, serial number of your equipment and the spare part number for the part you need. The spare part list is at the back of this manual. Use only spare parts mentioned in the spare part list.

TECHNICAL SPECIFICATIONS

Length	200 cm
Width	48 cm
Height	56 cm
Weight	46 kg

The R60 meets the requirements of the EU’s EMC Directives on electromagnetic compatibility (89/336/EEC). This product therefore carries the CE label.

The R60 meets EN precision and safety standards (EN-957).

Due to our continuous policy of product development, Tunturi reserves the right to change specifications without notice.

NOTE! The instructions must be followed carefully in the assembly, use and maintenance of your equipment. The warranty does not cover damage due to negligence of the assembly, adjustment and maintenance instructions described herein. Changes or modifications not expressly approved by Tunturi Oy Ltd will void the user's authority to operate the equipment!

We wish you many enjoyable trainings with your new Tunturi training partner!

9