CLEANING
Before cleaning, turn unit off at power switch.
1.CLEANING THE INTERIOR AND EXTERIOR
-The interior and exterior of the unit can be cleaned using warm water with soap.
-Do not use an abrasive cleaner because it will scratch the surface.
2.CLEANING THE CONDENSER FINS
-To maintain proper refrigeration performance, the Condenser coil must be free of dust, dirt, and grease.
This will require periodic cleaning. Condenser fins should be cleaned at least every three months (90 days) or as needed.
-To clean condenser, unplug at power cord. Condenser can be cleaned with vacuum. brush, or CO2 (high pressure air).
3.CLEAN THE DRAIN PAN
-Empty the Drain Pan which is located under the unit, periodically.
-When reinstalling Drain Pan, make sure Drain Hose is placed back in pan.
4.CHECK AFTER CLEANING
-Plug unit back in and turn on power switch.
-Check that the unit is operating properly.
CAUTION
1.POWER CORD
-Be sure the power cord is connected to the proper voltage.
-A protected circuit of the correct voltage and amperage must be run for connection of the line cord.
-Turn ‘off’ the power switch before disconnecting the power cord, whenever performing maintenance functions or cleaning the refrigerated cabinet.
-Compressor warranties are void if compressor burns out due to low voltage.
2.RE-STARTING
-If disconnected, wait 5 minutes before
3.POSITIONING DRINKS
-Do not obstruct the air inlet which is located at the back inside of the unit.
8
Turbo air
