BASIC
OPERATION
1.Plug in and turn on the power and lamp switch located on the top of the bottom grille right side.
The Display panel will be lighted and make a beep sound. The compressor will begin to run. After turning on the power, the fluorescent lamp will come on in a few minutes.
2.The default temperature setting is No.
The default temperature setting is No.
The default temperature setting is No.
3.The compressor is automatically cycled by the electronic controller (PCB,
4.The Defrost cycle is automatically controlled by the
5.Push the temperature up button for higher temperatures and the temperature down button for lower temperatures.
6.Evaporator fan motor will run after all doors are completely closed.
7.Good Air Flow in freezer is critical.
Be careful to load product so that it neither presses against the back wall, nor reaches within four inches from the evaporator compartment.
5
Turbo air
