user manual

TA-500

TS-890 Tilting Straps

0.5m

4.5m

The tilting strap, TS-890, is in two parts. The longer part is attached to the tilt strap point on the flying bar using the buckle at its end. The other part of the strap with the ratchet is hooked into the tilt strap point on the underside of the bottom enclosure. The free end is then threaded through the ratchet and the strap tightened to achieve the desired tilt. The tilt strap is designed to ratchet in both directions so that the amount of tilt on a column may easily be increased or reduced incrementally. The ratchet is double acting serving to ensure the safety of the operator by limiting the swing of the cluster when letting off the load.

Integral Flying Hardware

Aspect cabinets are flown and connected in vertical columns by means of the integral flygear that is rebated into the cabinet sides. In this way the load of the cluster is taken entirely through the steelwork and not through the box. It essentially consists of a moveable drop link that engages into a receptacle in the cabinet below with a choice of inter-cabinet angles.

All parts of the flygear are fitted flush with the woodwork of the cabinet, and can quickly and easily be removed for safety testing using a Torx TX20 bit.

The following diagram decribes the various parts of the flygear.

TA-500 user manual Page 27

Page 27
Image 27
Turbosound TA-500HM, TA-500TDP, TA-500HDP, TA-500DP user manual TS-890 Tilting Straps, Integral Flying Hardware