Turbosound TCS-1061 quick start Tri-ampto bi-ampconversion, TCS series, Quick Start Guide

Quick Start Guide

TCS series

Tri-amp to bi-amp conversion

The conversion is achieved by changing the position of a jumper on the crossover board located inside the left side driver access door (when viewed from the front). The default jumper position as shipped from the factory is TRI-AMPas shown here.

For TCS-1061/100 wide dispersion products relocate the jumper from the TRI-AMPPCB header to the centre position (BI-AMP ‘HW’ HORN) as shown below.

For TCS-1061/75 narrow dispersion products relocate the jumper to the left end of the PCB, furthest away from the access door (BI-AMP ‘H’ HORN) as shown below.

TCS series Quickstart Guide v1.0 - Page - 7