Quick Start Guide
TCS series
FK-1061 Flying Kit
Enables suspension of one column of
The kit consists of:
2 x flybars
2 x
2 x blanking plates
4 x M6 x 20mm socket head screws
4 x M6 split washer
The single flybar provides three pick up points to allow for either a single lift point or double lift points, or to provide a single pull- back point or two
BLANKING PLATE
FLYBAR
Rigging an Array of up to 5 cabinets with the
1.Attach a flybar to the front flying strips of the first cabinet using the M6 x 20mm socket head bolts and split washers provided. This flybar will become the lifting bar and is used to hang the array. Attach this bar to the external rigging or motor.
2.Remove both of the rear flyplates from the first cabinet and replace them with the two blanking plates supplied with the flying kit.
3.Lift the flybar array together with the first cabinet, and connect the second and additional cabinets underneath the first cabinet using the four M6 x 45 high tensile screws and M6 split washers provided, and set the inter- cabinet angles as desired. Tighten all fixings and raise the array into position.
4.Fit a blanking plate to each end of the remaining flybar using the M6 x 20mm socket head screws and split washers provided.
5.When attaching to static rigging positions the suggested method is to
TCS series Quickstart Guide v1.0 - Page - 5