user manual
QLight™ DP series
quicklinks or shackles. When used in this way the load is taken through the flying strips rather than through the woodwork of the enclosure.
Side-mounted flying strips can be fitted to the sides of QLight™ subwoofers to enable them to be flown as part of a permanent installation. Two different lengths of flying strips are optionally available for flying enclosures in either a vertical or horizontal orientation. These are fitted by removing the countersunk bolts on the top and sides of the cabinet and replacing them with the M10 bolts provided with the hardware. Two flying strips are required for each enclosure. This method offers a simple and cost effective method of flying single or multiple TQ-425 enclosures, with the load being taken through the steel strips rather than through the woodwork of the enclosure. Enclosures may be arranged in a vertical column by coupling the flying strips together using QL-75 quicklinks or shackles. FF-425 flying strips are load tested.
WARNING: Rigging eyebolts must not be used for flying this enclosure. You must use the optional Turbosound steel flying strips described above.
The universal FB-12 flybar assembly enables the use of several different fixing methods for the TQ-445DP, all shown in the diagram here. The flybar is attached to the cabinet using a pair of captive M10 shoulder eyebolts (supplied with the flybar assembly). There are 12 attachment points equally spaced along the length of the spine of the flybar. Depending on which point is chosen for the given attachment system, a wide range of downward inclination angles can be achieved over a range of approximately 70 degrees. The design of the flybar even allows for upward angles, for example for coverage of balconies that are higher than the loudspeaker location.
QLight DP series manual page 22
