Disarming the System
Enter the premises only through the door(s) designated by your installer as the
If an alarm occurred during the period the system was armed, the “System” light and the Zone Light of the zone that caused the alarm will flash for two minutes. After the two minute period, the “System” light and Zone Light will stop flashing and the system will return to the ready state. Pressing the [#] key during the two minute period will cancel the alarm memory display.
If a trouble is present when the system is disarmed, the “System” light will come ON (See Viewing Trouble Conditions section to determine the source of the trouble). Note that troubles will not display while the system is in the Alarm Memory Display Mode.
If you return home and find that an alarm has occurred while you were away, it is possible that an intruder may still be on the premises. Go to a neighbour's house, and call the local police to investigate.
Quick Arm Feature
Your Installer will inform you of whether or not that
Press [#] to return to “Ready”.
Door Chime Feature
The door chime feature is used, while the system is disarmed, to provide a tone from the keypad each time a door or window is opened or closed. The doors and windows which will provide this indication are programmed by your installer.
Enter [∗ ][6][Master Code][6] to turn the door chime feature ON and OFF. When the command is entered, the keypad buzzer will beep 3 times if the door chime feature is being enabled, and will sound one long beep if it is being disabled.
Press [#] to return to “Ready”.
Alarm Test
Enter [∗ ][6][Master Code][8] for a
Press [#] to return to “Ready”.
4