Tyco Electronics M7100IP 12.12 EDACS CONVENTIONAL P1 SCAN , 12.13 DYNAMIC REGROUP OPERATION , 12.14 RADIO TEXTLINK OPERATION (EDACS ONLY)

the n keylight remains lit. If the site does not receive the message properly, a low-pitched tone

sounds and the n keylight will blink.

If an incorrect message text was selected or the incorrect number button was pressed, the message

text can be changed during the pre-programmed time-out period by pressing another number

button. The message text selection can also be cancelled by pressing the c button prior to the

time-out period.

To view the currently selected message text after it has been transmitted, press the n button

and then the c button prior to the time-out period. If the message text was not sent

successfully to the site, the text associated with the message will flash in the display.

12.12 EDACS CONVENTIONAL P1 SCAN

This feature permits the radio user to scan a pre-programmed conventional system and channel as a Priority

1 (P1) channel while the radio is selected for EDACS trunked system. If activity is detected on the

conventional P1 channel, the radio will unmute and remain on this conventional channel for the

programmable hang time.

The radio must be pre-programmed to designate a button for scan ON/OFF operation.

12.13 DYNAMIC REGROUP OPERATION

Dynamic regroup operation permits multiple talk groups (up to eight) to be added to a radio via the

Communications Systems Director (CSD). The radio must be pre-programmed to respond to regrouping.

Dynamic regrouping will not be activated in a radio until an activation message is sent by the system

manager. Each radio that receives and acknowledges regrouping instructions is successfully regrouped.

Pressing and holding the C (Scan Model) or c (System Model) button for 2.5 seconds toggles

the user into and out of the dynamic regroup group set. A double beep will sound for entry or exit. The

display will indicate REGR_0x where "x" is a digit of 1 to 8 indicating the group when dynamic regroup

has been enabled by the user. If the radio is in dynamic regroup and the user selects a group that has not

been regrouped, the display will show NO ENTRY. The radio will be prevented from transmitting and

receiving calls in this condition except for scanned groups.

If the pre-programmed group set on the currently selected system contains an EMER/HOME

group and the radio is in dynamic regroup, the radio will exit dynamic regroup and declare the

emergency on the HOME group. If no EMER/HOME group is present, the radio will declare the

emergency on the currently selected dynamic regroup group.

12.14 RADIO TEXTLINK OPERATION (EDACS ONLY)

The Radio TextLink option provides a simple means of exchanging text messages. This section describes

how to send and receive text messages if the Radio TextLink feature is enabled.

1. Select SEND MSG with the M and scroll through the list of pre-defined messages using

, or ..

2. Select the desired message with the M key.