15R and 15WC Models
10. Fasten upper hinge to |
unit (three screws). |
Partially tighten screws. |
See Figure 11. |
7.Remove the bottom pivot plate from the door (two screws). Invert and install it on the top of the opposite side of the door.
11. Adjust door to assure |
proper seal. Tighten |
upper and lower hinge |
screws securely. |
12. Replace three plastic |
plugs removed in Step 8 |
into holes on top of |
unit. Replace screws in |
holes in bottom of unit |
on opposite side. |
8. Locate the bushing saved |
in Step 3. Holding the |
bushing in place, lift the |
door onto the newly |
located bottom hinge |
bracket. See Figure 14. |
9. Onto the new top pivot |
plate’s post, assemble the |
bushing saved in Step 2 |
and the hinge plate saved |
in Step 1. Install three |
screws to attach new top |
Door |
Pivot Plate |
Bushing |
Figure 14 |
Stainless 15R Units and All 15WC Units
Note: The grille should not yet be installed. If it has been installed, remove it for door reversing. See Page 11.
hinge plate to cabinet. |
10. Adjust door to assure proper seal.
Stainless 15R Refrigerator models and Black and Stainless 15WC Wine Captain models are reversible by moving the hinge hardware to the opposite side (Figure 12) as follows:
1.Remove the top hinge plate (three screws) from cabinet and save.
2.Remove the bushing from the top pivot plate’s post and save. See Figure 13.
3.Being careful not to lose the bottom pivot plate’s bushing (Figure 14), remove the door by lifting it off the bottom hinge bracket. Save the bushing.
Hinge |
Plate |
Hinge |
Bracket |
Figure 12 |
Other Site Requirements
Power Supply
The unit requires a grounded and polarized 115 VAC, 60 Hz, 15A circuit (normal household current). See Electrical Specifications on Page 10.
Environmental Requirements
The surrounding air temperature must be at least 50°F (10°C) but must not exceed 110°F (40°C). Units may be installed outdoors in a covered area. The unit must not be located near
4.Remove bottom hinge bracket from cabinet (two screws). See Figure 5. Remove screws on opposite side of cabinet (Figure 6). Note that there may be a nut behind one or both screws on either side.
5.Install hinge bracket on opposite side, bottom of cabinet. See Figure 7.
Replace nut on back side where installed. Align hinge outer edge with cabinet before tightening screws.
6.Remove the top pivot plate from the door (two screws). Invert and install it on the bottom of the opposite side of the door.
Bushing |
Pivot Plate |
Door |
Figure 13 |
02/2005 | 7 |
