15R and 15WC Models
Side-By-Side Installation Instructions
4 Prepare/Install Door Panel
For a complete refreshment center, install two of the 15 series units side by side: 15R and 15WC.
•
For example:
Placing a 15R next to a 15WC would require a
•No trim kit is required. However,
•Units must operate from separate, properly grounded electrical receptacles placed according to each unit’s Electrical Specifications.
Typical |
|
| |
to |
|
35" | 7" |
| |
1/4" Space |
|
Between Appliances | |
Figure 15 |
|
15R Refrigerators will accept a Custom 1/4" Thick Insert to harmonize with or accent the surrounding decor.
If this treatment is not included in this installation, go on to 5 Adjust Door.
Custom 1/4'' Thick Door Panel Insert
(15R Refrigerator Units Only)
Door Panel Preparation
A custom door panel can be inserted into the doorframe. Custom door panels can be flat or raised, as long as the maximum panel thickness where inserted into the door reveal (channel) is
IMPORTANT
Raised panels will reduce the door’s 90° swing/zero clearance if the unit is installed next to a wall or similar type of structure (see Page 5).
Cut the panel insert to the following dimensions.
Custom 1/4" Dimensions for Black units:
Width:
Height:
Custom 1/4" Dimensions for Stainless units:
Width:
Height:
The door panel must not weigh more than 20 lbs.
Door Panel Installation
Install the insert as follows:
CAUTION
Use care when handling the insert. Insert edges may be sharp.
1.Remove top hinge from cabinet (three screws). See Figure 14. Hold door to keep it from falling.
2.Lift the door off the bottom hinge.
8 | 02/2005 |
