2075WC/2075WCOL Wine Captain®
www.U-LineService.com 802/2005
™
Staining Wood Trim a Different Color
1. Remove each wine rack by sliding it out and up. See
Figure 12.
2. Remove and save screws securing wood trim to the
racks.
3. Apply Minwax Water-Based Wood Stain to wood with a
synthetic foam brush. Stain must penetrate
approximately 3 minutes. After this period, while stain
is still wet, take a stain-dampened rag and remove all
excess stain. Wipe in the direction of the grain with
medium pressure to achieve the desired stain color.
4. After 2 hours, repeat Step 3.
5. Allow stain to dry for a minimum of 3 hours before
finishing.
6. Sand the wood with very fine sandpaper to smooth the
surface from the staining process.
7. Remove sanding dust with a tack cloth.
8. Apply a thin coat of Minwax Polycrylic, following
container label for directions. Allow to dry 24 hours.
9. Lightly sand, tack and reapply 2 times, if desired.
10.Allow the final coat to dry for 24 hours.
11.Reinstall wood trim to wine racks using screws removed
in Step 2.
12.Reinstall wine racks in unit.
13.For 2075WC units, go on to
5 Adjust Door
.
Overlay Frame
(2075WCOL Units Only)

Frame Preparation

An overlay frame covers the door frame to give a built-in
appearance. Appropriate hardware and a copy of these
instructions will be included in the unit.
IMPORTANT
The thickness of the wood overlay frame must be 3/4".
The door frame must not weigh more than 20 lbs.
1. Cr eate an overlay frame to the dimensions shown in
Figure 13.
IMPORTANT
Rear View of wood frame for right-hand hinge shown.
Use mirror image for left-hand hinges.
27-3/4"
30"
21-1/2"
23-3/4"
Rear View
of
Wood Frame
1/8"
13/16"
1/8"
Relief Notch for Pivot Plate
(Right Hand Hinge Shown)
3/4"
Figure 13