U-Line ADA24RG manual Cut-Out Dimensions, Prepare Site, 1175, 1075 & 75F Series, ADA24 Series

4 Prepare Site

Your U-Line product has been designed for either free-standing or built-in installation. When built-in, your unit does not require additional air space for top, sides or rear. However, the front grille must NOT be obstructed and clearance is required for an electrical connection in the rear.

WARNING

Unit can NOT be installed behind a closed cabinet door.

WARNING

SHOCK HAZARD — Electrical Grounding Required.

•Never remove the round grounding prong from the plug and never use a two-prong grounding adapter.

•Never use an extension cord to connect power to the unit.

IMPORTANT

Electrical installation must observe all state and local codes. This unit requires connection to a grounded (three- prong), polarized receptacle that has been placed by a qualified electrician.

The unit requires a grounded and polarized 115 VAC, 60 Hz, 15A power supply (normal household current). An individual, properly grounded branch circuit or circuit breaker is recommended. GFCI (ground fault circuit interrupter) is usually not required for fixed location appliances and is not recommended for your unit because a GFCI could be prone to nuisance tripping. However, be sure to consult your local codes.

Cut-Out Dimensions

1175, 1075 & 75F Series

Follow the cut-out drawing. The 24-1/4" width allows 1/4" for ease in installation and removal of the unit. 24" is the cabinet depth in most installations.

24"

34-1/4"

to7"

35-1/8"

4"

24-1/4"

1115 Series

Follow the cut-out drawing The 15-3/16" width allows 1/4" for ease in installation and removal of the unit. 24" is the cabinet depth in most installations.

34-1/8"	24”
to
35"	7"
	1-1/2"
	15-1/4"

29 Series

Follow the cut-out drawing. The 21-1/16" width allows 1/4" for ease in installation and removal of the unit. 24" is the counter depth in most installations. The unit is 23" deep including the door.

Filler Panel (Not Provided by U-Line) – May Be Added Above or Below Unit to Enclose for a Built-In Look

Typical
Counter
Height
34-1/4"
to	24"
35-1/8"	Minimum
Cut-Out
Height	7"
28-5/8"
to
28-7/8"

1-1/2"

21-1/16"

ADA24 Series

Follow the cut-out drawing The 24 1/4" width allows 1/4" for ease in installation and removal of the unit. 24" is the cabinet depth in most installations.

24"

32”

7"

4"

24-1/4"

Prepare Site 3