U-Line ADA24RGL manual Invert

ADA SERIES

	Hinge
Plastic		Plastic
Plug Hole		Plug Hole
	Screw
Right Side		Left Side
Door Swing		Door Swing
Right Side	Invert	Invert
Hinge	Screw	Hinge
		ULIN_0106_A

Figure 15

5.Remove pivot screw from top hinge, invert screw and reinstall pivot screw in top hinge (Figure 15). Do not install hinge on cabinet at this time.

ULIN_0107_A

Figure 16

6.Remove bottom hinge from cabinet (four screws) and screws on opposite side of cabinet (Figure 16).

7.Remove pivot screw from bottom hinge, invert screw and reinstall pivot screw in hinge (Figure 15).

ULIN_0160_A

Figure 17

8.Install bottom hinge on cabinet, opposite side, aligning flat edge of hinge with outer edge of unit (Figure 17). Partially tighten screws.

1

ULIN_0109_A

Figure 18

9.Relocate plastic spacer/bushing (Figure 18) on bottom of door to the opposite side. Clean out bushing hole in door bottom if necessary.

ULIN_0110_A

Figure 19

10.Place door on lower hinge pin. Align flat edge of top hinge with outer edge of unit and fasten upper hinge to unit (four screws) (Figure 19). Partially tighten screws until door is aligned.

11.Adjust door to assure proper seal. Tighten upper and lower hinge screws securely.

12.Replace four plastic plugs removed in Step 4 into holes on top of unit. Replace screws in holes in bottom of unit on opposite side.

13.Replace the grille.

ADA24 11