U-Line ADA24RGL manual Wire Shelf Removal/Installation, Light Bulb Replacement

ADA SERIES

Wire Shelf Removal/Installation

Reposition the shelves as follows:

Figure 10

1.Remove shelf retention clip.

2.Pull shelf out about 6" (Figure 10, 1), until back of shelf clears the “hump” on the right-hand side.

3.Tilt up right-hand edge of shelf (Figure 10, 2).

4.Remove shelf from unit by pulling out (Figure 10, 3). Insert the shelves as follows:

1.To move to a different position in the unit, insert shelf at an angle, approximately 15-20°, over the rib in the side of the unit where you want to place the shelf. The shelf must be started into the unit at an angle to clear the door.

2.Continue to slide the shelf into the unit at an angle until it clears the door.

3.Lower the shelf and push it in completely.

4.Install shelf retention clip.

Light Bulb Replacement

To replace the light bulb in your U-Line unit:

2

1

ULIN_0001_A

Figure 11

1.Grasp the edges of the light housing lens

(Figure 11, 1) opposite the exposed tab, and gently push the lens towards the tab (Figure 11, 2).

2.Pull the edge of the lens down (Figure 11, 1), and swing it out of the light housing.

IMPORTANT

ALWAYS use a genuine U-Line replacement bulb (P/N 31317) in the light housing. Use of any other bulb within the housing will generate excessive heat, causing damage to the light housing and cabinet interior, and compromising the precise temperature control of your unit.

3.Replace the bulb only with a genuine U-Line P/N 31317 replacement.

4.Replace the lens by first inserting the tab side back into the housing at a slight angle. While gently pushing the lens towards the tab end, push the free end up into the housing, and release when you will hear a snap/click.

ADA24 9