Design ■ Features ■ Performance

GENERAL INFORMATION

ÉCHELON™ DOOR ADJUSTMENT

All Échelon™ model doors are aligned at the factory before shipment. Occasional re-adjustment may be necessary, especially if an Overlay Panel is installed. The following procedure will correct for up to 1/4" alignment.

IMPORTANT

The door should never be flush with the top of the cabinet. Even when level, the top edge of the door will be 1/8" below the top of the cabinet (see Figure 1).

1/8"

DOOR001

Figure 1

To adjust door:

1.Compare the top edge of the door (opposite the hinges) to the top edge of the cabinet and note the type (up or down) of adjustment needed.

2.Remove the top hinge pivot pin with a 7/64" hex wrench (see Figure 2) and lift door off bottom hinge pin. Be careful not to lose door closer inserts (see Figure 5).

Note: The hinge plate on some Échelon™ models does not have the holes slotted for adjustment. New hinge plates are available from U-Line Customer Service.

3. With door upside-down, inspect the bottom hinge plate mounting holes.

a.If your plate has slotted mounting holes, loosen but do not remove the two hinge plate screws.

b.If your plate does not have slotted mounting

holes, remove the old plate and install the new plate with the notch to the inside of the door (see Figure 3).

UL310

Figure 2

11