GENERAL INFORMATION
Design ■ Features ■ Performance
4.If door edge opposite the hinges needs to move up, move plate toward outside of door. If door edge needs to move down, move plate toward inside of door (see Figure 3). Repeat until top edge of door is parallel with top of cabinet and tighten screws securely.
|
|
| SLOTTED | |
SLOTTED |
|
| MOUNTING | |
NOTCH |
| HOLES | ||
MOUNTING |
|
|
| |
HOLES |
|
| ALL WINE | |
| ALL MODELS |
| ||
|
| CAPTAIN MODELS | ||
| EXCEPT WINE CAPTAIN |
|
| |
|
| RAISE | LOWER | |
RAISE | LOWER | OUTSIDE | OUTSIDE | |
DOOR EDGE | DOOR EDGE | |||
OUTSIDE | OUTSIDE | |||
|
| |||
DOOR EDGE | DOOR EDGE |
|
|
DOOR003
Figure 3
5.If you have an older model, you must slot the door frame to accommodate the door closer boss. Using the bottom hinge plate pivot hole as a guide, slot the frame hole by using an 11/32" drill.
|
|
| SLOTTED | |
SLOTTED |
|
| MOUNTING | |
NOTCH |
| HOLES | ||
MOUNTING |
|
|
| |
HOLES |
|
| ALL WINE | |
| ALL MODELS |
| ||
|
| CAPTAIN MODELS | ||
| EXCEPT WINE CAPTAIN |
|
| |
|
| RAISE | LOWER | |
RAISE | LOWER | OUTSIDE | OUTSIDE | |
DOOR EDGE | DOOR EDGE | |||
OUTSIDE | OUTSIDE | |||
|
| |||
DOOR EDGE | DOOR EDGE |
|
|
DOOR003
Figure 4
6.After adjustment is complete, remove the door closers from the bottom hinge, clean thoroughly and apply petroleum jelly to the mating surfaces of the closers (see Figure 5). Be sure that bosses on closers align with holes in hinge and hinge plate. Mount door and install top hinge pivot pin.
DOOR 
CLOSER
INSERTS
BOSS
UL312
Figure 5
12