Design ■ Features ■ Performance

CLR2060 MODEL

AUTOMATIC CLEAN CYCLE INSTRUCTIONS

To maintain operational efficiency, clean unit every six months (depending on water conditions more or less frequent cleaning may be necessary). If the ice maker requires more frequent cleaning, consult a qualified plumber to test the water quality and recommend appropriate treatment. Use only U-Line Ice Machine Cleaner (part number 41978).

!

Use only U-Line Ice Machine Cleaner (part number 41978). It is a violation of Federal law to use this solution in a manner inconsistent with its labeling. Use of any other cleaner can ruin the finish of the evaporator and will void the warranty. Read and understand all labels printed on the package before use. Ice machine cleaner is used to remove Lime scale and other mineral deposits. Refer to the following steps for mineral deposit removal.

1.Set the cycle selector switch (located in the center of the grille) to OFF. Allow the ice to melt off of the evaporator.

2.Remove all ice from the storage bin.

3.Remove inside front cover by gently pulling away from sidewall. See Figure A.

4.Remove the overflow tube by lifting it up while using a slight back and forth motion to loosen it from the drain hole. See Figure B. The water in the reservoir will flow down the drain.

5.Replace the overflow tube after all the water has been drained from the reservoir.

6.Move the cycle selector switch to the CLN position.

7.When water begins to flow over the evaporator, approximately three minutes, add one packet of U-Line Ice Machine Cleaner to the reservoir.

8.Reinstall inside front cover.

9.When the self cleaning process stops, approximately 45 minutes, it may be desirable to clean the storage bin. See INTERIOR STORAGE BIN

CLEANING.

10.Move the cycle selector switch to the ICE position to resume ice production.

FRONT COVER

UU•LINE

Figure A

UL208

OVERFLOW

Interior Storage Bin Cleaning

UL20

Figure B

1.Disconnect power from the ice maker.

2.Remove any ice from the storage bin.

3.Wipe down the storage bin with a solution of non-abrasive mild soap or detergent and warm water. Rinse with clean water. Sanitize the bin with a solution of one tablespoon of bleach and one gallon of water. Rinse thoroughly with clean water.

4.Check that all drain connections are in place.

5.Reconnect power to the unit.

93