U-Line CO2175DWR manual Leveling, Light Bulb Replacement

Leveling

NOTE: It is important that the unit is level. If unit is not level, the ice mold may not fill evenly.

ULIN_0045_A

Figure 15

1.Use a level to check the levelness of the unit from front to back and from side to side. Place the level along top edge and side edge as shown (Figure 15).

ULIN_0046_A

Figure 16

2.If the unit is not level, adjust the feet on the corners of the unit as necessary (Figure 16).

3.Check the levelness after each adjustment and repeat the previous steps until the unit is level.

Light Bulb Replacement

To replace the light bulb in your U-Line unit:

2

1

ULIN_0001_A

Figure 17

1.Grasp the edges of the light housing lens

(Figure 17, 1) opposite the exposed tab and gently push the lens toward the tab (Figure 17, 2).

2.Pull the edge of the lens down (Figure 17, 1) and swing it out of the light housing.

IMPORTANT

ALWAYS use a genuine U-Line replacement bulb (P/N 31317) in the light housing. Use of any other bulb within the housing will generate excessive heat, causing damage to the light housing and cabinet interior, and will compromise the precise temperature control of your unit.

3.Replace the bulb only with a genuine U-Line P/N 31317 replacement.

4.Replace the lens by first inserting the tab side back into the housing at a slight angle. While gently pushing the lens towards the tab end, push the free end up into the housing, and release when you will hear a snap/click.

14 CO2175DWR