U-Line U-C2275DWRS-00, U-2175RFS-01, U-2175RFS-00 manual Control Dial, Air Flow, Initial Startup

Product Operation Manual Control

Air Flow

NOTICE

The unit requires proper air flow to perform at its highest efficiency. Do not block the front grille or internal fans at any time, or the unit will not perform as expected. Do not install the unit behind a door.

CO29FF

Initial Startup

All U-Line controls are preset at the factory. Initial startup requires no adjustments.

NOTICE

U-Line recommends allowing the unit to run overnight before loading refrigerator or freezer with product.

NOTICE

On ice maker equipped units, it is possible that dirt or scale will dislodge in the water line. Always throw away all ice cubes made during the first two to three hours of operation.

OFF

ON

To turn the unit on or off:

Depending on model, a rocker switch will be locate below the temperature control dial in the center of the grille (2), inside the door on the front panel, or behind the grille. To toggle the power state simply switch the rocker from one side to the other.

Control Dial

Combo Models provide two temperature zones within the cabinet to satisfy the specific storage requirements.

The control dial sets a single continuous temperature. This set- point temperature is a base setting used by the controller to maintain the temperature zone in the unit. The factory default setting is number 3 or 4. The setpoint temperature is a gauge for further temperature adjustments.

6 u-line.com