![](/images/new-backgrounds/1310494/31049419x1.webp)
If you have wall mounted the base, you must remove the beltclip to charge the handset facing forward.
M O U N T I N G T H E B A S E U N I T O N A W A L L
Standard wall plate mounting
This phone can be mounted on any standard telephone wall plate. 1
1 Snap the wall mount adapter into the notches on the base.
2 Plug the telephone line cord to the TEL LINE jack and the AC | 2 - 7 | |
adapter to the DC IN 9V jack. | ||
|
3 Plug the telephone line cord into the telephone outlet.
4 Wrap the AC adapter cord inside the molded wiring channel. Then wrap the cord around the strain relief notch.
5 Plug the AC adapter into a standard 120V AC wall outlet.
6 Raise the antenna to a vertical position.
7Align the mounting slots on the base with the mounting posts
on the wall. Push in and down until the phone is firmly seated.
8 | On the base unit, pull the handset retainer out of the slot. | |
| Rotate it clockwise 180 degrees. | 8, 9 |
9 | Flip the retainer from front to back. Slide it back into the slot | |
| so that the lip of the retainer is up and | is down. The |
| retainer holds the handset in place. |
|
[ 8 ] | G E T T I N G S T A R T E D |