![](/images/new-backgrounds/1310494/31049487x1.webp)
•During the remote operation, rC displays on the base.
•You must enter a command within 15 seconds of entering command waiting mode or the answering system automatically hangs up and returns to standby.
•The system will only playback messages for four minutes and then it returns to command waiting mode. To continue playing your message, press
# then 2 again within 15 seconds.
Remote access away from home
You can operate your answering system from a remote location using any
1Call your telephone number.
2While the greeting message is played, press # and your PIN code.
If the answering system is off, let it ring 10 times until the greeting message is played. Then,
press # and your PIN code.
3The answering system announces the time and day stamp and the number of messages stored
in memory. Then the message playback automatically begins.
4You may continue to listen to your message, or you may select a command from the following chart.
Command | Function |
#then 1 Repeat a message
#then 2 Playing your messages
#then 3 Skipping a message
#then 4 Deleting a message
#then 5 Stop message playback
#then 6 Answering system on
#then 7 Voice memo record/stop (up to 4 minutes recording time)
#then 8 Greeting message record/stop
#then 9 Answer system off
# then * | Room monitor |
5After all of your messages have played, or the playback time exceeds 4 minutes, you will hear that the intermittent beeps indicating that the system is in the command waiting mode. You
may enter another command at this time from the chart above.
6When you finish, hang up to exit the system.
The answering system automatically returns to standby.
[ 42 ] | T H E I N T E G R A T E D A N S W E R I N G D E V I C E |