Uniden 4541 manual B. Install the rechargeable battery pack into the handset, or electrical hazard

B. Install the rechargeable battery pack into the handset

The handset is powered by a rechargeable battery pack. The battery recharges automatically when the handset is placed in the base unit.

NOTE: If your home has specially wired alarm equipment connected to the telephone line, be sure that installing the system does not disable your alarm equipment. If you have questions about what will disable your alarm equipment, contact your telephone company or a qualified installer.

1) Press down on the handset battery case cover (use the finger indention for a better grip) and slide the cover downward to remove.

2) Plug the battery pack connector (red & black wires) into the jack inside the battery compartment (the connector notches fit into the grooves of the jack only one way).

Match the wire colors to the polarity label in the battery compartment, connect the battery and listen for a click to insure connection.

3) Fit the battery pack into the battery compartment.

4) Before replacing the battery cover, pull on the battery wires slightly. If the connection is secure, the jack will stay in place. Then place the battery case cover back on the handset by sliding it upwards until it clicks into place.

NOTE: For optimum performance, use only the

Uniden Battery (BT- 1007) supplied with your phone.

C. Connect the base unit and charge the handset

1) Connect the AC adapter to the DC IN 9V jack
and a standard 120V AC wall outlet.		Route the cord.
2) Set the base unit on a desk or tabletop, and
place the handset in the base unit with the
keypad facing forward.
3) Make sure the in use/ LED illuminates. If the
LED does not illuminate, check to see that
the AC adapter is plugged in and the handset
makes good contact with the base charging
contacts.
NOTICE: Do not place the power cord
where it creates a trip hazard or where
it could become chafed and create a fire
or electrical hazard.
NOTE:
• Use only the supplied AD-0001 AC
adapter. Do not use any other AC
adapter.
• Connect the AC adapter to a
continuous power supply.
• Place the base unit close to the AC
outlet to avoid long extension cords.
4) Charge your handset at least 15-20 hours
before plugging the phone line.
5) Once the handset battery pack is
fully charged, connect the telephone
line cord to the TEL LINE jack and		Route the cord.
a telephone outlet. If your telephone	Modular
outlet isn’t modular, contact your
telephone company for assistance.