Uniden 900 MHz manual Using Your Phone, Choose the dialing mode, Making and Receiving Calls

5)Connect the telephone line cord to the TEL LINE jack and a telephone outlet once the handset is fully charged.

TIP: If your telephone outlet isn’t modular, contact your telephone company for assistance.

D. Choose the dialing mode

Modular

Most phone systems use tone dialing which sends DTMF tones through the phone lines. However some phone systems still use pulse dialing such as in rural areas. The default setting is tone dialing. Depending on your dialing system, set the mode as follows:

1)Press and hold flash until you hear a confirmation tone.

2)To set the dial mode for pulse dialing, press #. Or to set the dial mode for tone dialing, press

*/tone. A confirmation tone sounds to indicate the setting is complete.

• If you are not sure of your dialing system, set for tone dialing. Make a trial call. If the call connects, leave the setting as is, otherwise set for pulse dialing.

• If your phone dialing system requires pulse dialing and you need to send DTMF tones for certain situations during a call, you may “switch-over” to tone dialing. (Refer to “Tone Dialing Switch-over”).

NOTE: Make sure your battery pack is fully charged before choosing the dial mode.

Using Your Phone

Making and Receiving Calls

		Handset On Base		Handset Off Base
Answer call	When the phone rings, remove the		Press talk, any number key, */tone, or #.
	handset from the base. (AutoTalk)
	1)	Remove the handset from the base and	1)	Press talk.
		press talk.
Make call	2)	The talk/batt low LED flashes and	2)	The talk/batt low LED flashes and
		turns on.		turns on.
	3)	Listen for the dial tone.	3)	Listen for the dial tone.
	4)	Dial the number.	4)	Dial the number.
Hang up	Press end or return the handset to the base. (AutoStandby)
	1)	Remove the handset from the base and	1)	Press talk.
		press talk.
Redial	2)	Listen for the dial tone.	2)	Listen for the dial tone.
	3)	Press redial/p to dial the last dialed	3)	Press redial/p to dial the last dialed
		number.		number.
Ringer Mute	None		Press end when ringing.

NOTES: • The redial/p key redials the last number dialed.

•The redialed number can be up to 24 digits long.

4