Page
To locate the handset (while it’s off the base), press find handset on the base. The handset beeps for 60 seconds.
Paging is canceled when pressing any key, find handset on the base or return the handset to the base.
Flash and Call Waiting
If you have “call waiting” service and a call waiting tone sounds while you are on a call, press flash to accept the waiting call. There is a short pause, then you will hear the new caller. To return to the original caller, press flash again.
NOTE: You must subscribe through your local telephone company to receive Call Waiting Service.
Storing a Phone Number in Memory
Your EXP370 Series has 10 memory locations for storing important telephone numbers.
1) Remove the handset from the base.
2) Press m. The talk/batt low LED flashes.
3)Enter the phone number, up to 16 digits. If a pause is needed during the dialing sequence, press redial/p to insert a pause. Each pause counts as a
digit and represents a two second delay in time between digits as they are sent.
4) Press m again.
5)Enter the memory location
RocketDial. You can store data in this location by pressing 1. A tone indicates that the number is stored. If you enter a number in a location that has a previously stored number it will overwrite the existing number without warning.
NOTES: • The pause button counts as one digit. Pressing redial/p more than once increases the length of pause between numbers.
•You have 30 seconds after pressing m to enter the number you wish to store. Otherwise, the handset will beep rapidly.
•You cannot store numbers in RocketDial.
Dialing a Stored Number
Using the memory location features
1)Press talk, then press m.
2)Enter the memory location
NOTE: If you select a memory location that does not have a stored number, the handset will beep rapidly and the phone will not dial.
6
