Uniden DECT2088 Series manual If you want to Press Then

Using the Answering System

To operate from a remote location, use any touch-tone telephone, and follow these steps:

) Call your telephone number and wait for the system to answer. If the answering system is off, it will answer after about ten rings and sounds a series of beeps.

2)During the greeting or the beeps (if answering system is off), press [0] and enter your security code/PIN within two seconds.

3)The answering system announces the current time and the number of messages stored in memory.. You hear “To play incoming messages, press zero-two. For help, press one-zero” followed by a beep.

4)Enter a remote command from the chart below. You have fifteen seconds to enter the first command; after the first command, you have two seconds to enter each command.

If you want to	Press	If you want to	Press
	[0] then [2]
Play incoming	The answering system plays back	Stop the current operation to
	messages for four minutes, then		[0] then [5]
messages	waits for another command. To	enter a different command.
	continue playing your messages,
	press [0] then [2] again.
Repeat this message	[0] then [1] (after the first four	Turn the answering system off	[0] then [9]
	seconds of this message)
Go back to the	[0] then [1] during the first four	Turn the answering system on	[0] then [6]
previous message	seconds of a message
Skip this message	[0] then [3]	Listen to the help prompts	[1] then [0]
Delete this message	[0] then [4]	Exit the system	Hang up.

5)When you finish, you will hear intermittent beeps indicating that the system is in the command waiting mode. Enter another command from the chart within fifteen seconds.

6)Hang up to exit the system. The answering system automatically returns to its normal standby setting.

51