Hitachi MK-96RD647-01 manual FCU Error Codes for Unix

FCU Error Codes for UNIX

If FCU for UNIX reports an error, use the Help-Errorcommand to view the most recent error. Table 7-3lists and describes the FCU error codes for UNIX and provides instructions for resolving each error condition. In Table 7-3,the error codes marked by an asterisk (*) may also be reported when I/O access contention for the FX volume occurs between the z/OS and open-system hosts. If the cause of the error cannot be identified as described in Table 7-3,check for any illegal I/O contention for the FX volume.

Note: Error codes with a negative value are FCU errors. Error codes with a positive value are system errors. UNIX system error codes are defined in the standard error file errno.h.

Note: The error codes with “(C)” in the “Error code” cell in Table 7-3are generated only when using with FX Code Converter. For details, please see the Hitachi Lightning 9900 V Series FX Code Converter User’s Guide (MK- 93RD152).

Table 7-3 FCU Error Codes for UNIX

Error		Error Message and Description	Recommended Action(s)
Code
-100		No parameter file	If you specified the parameter definition file using the
		The FCU parameter definition file	[param] option, make sure that the specified file exists and
			the name is correct.
		could not be found.
			If you did not specify the [param] option when you started FCU, make sure
			that the default parameter definition file exists (fcudata.param in the current
			directory).
-101*	Parameter file: Open error		Display the system error code using the Help-Error
		An error occurred when opening	command. Please refer to the OS user manual for
			information on system errors.
		the parameter definition file.
-102*	Parameter file: Read error		Display the system error code using the Help-Error
		An error occurred when reading	command. Please refer to the OS user manual for
			information on system errors.
		the parameter definition file.
-103*	Parameter file: No valid data		Make sure that the FCU initiation parameters are entered
		The parameters in the parameter	correctly in the parameter definition file.
		definition file are not valid.
-107		Parameter file: CODE_CONV error	Make sure that the code conversion is specified as either EA
		The code conversion specified in	or No.
		the parameter definition file is not
		valid.
-108		Parameter file: PADDING error	Make sure that the padding is specified as either Yes or No.
		The padding option specified in
		the parameter definition file is not
		valid.

Troubleshooting 7-7

Hitachi USP V Cross-OS File Exchange User’s Guide