Uniden DS 815 quick start Functions such as Call Transfer Registration Process

REGISTRATION

	The original handset supplied with the Main Base is already registered as handset 1, this leaves handset
	numbers 2 - 7 available. It is very important to allocate each handset a different number to enable
	functions such as Call Transfer.
	Registration Process
If a handset is registered at	Follow this process for each additional handset (DS805) that needs to be registered to the Main Base
	or for registering your Main Handset.
any time as handset 1, all	1.	Remove the handset from its charger
other handsets will need to	2.	Press flash/reg on the handset (Fig 1).
be registered again from	3 Press the number 2 (Fig 2) for handset 2.
Step 1.			REGISTER AS
	Fig 1.		HAND #2
			Fig 2.
If you have additional			REGISTER AS
handsets, repeat the same
			HAND # (3 - 7)
process, but at Step 2 select
			Fig 3.
a number from 3 - 7 to
	4. Place the handset in the Main Base Unit (Fig 4).
register the next handset as
	5. Press and hold the Registration button located on the back of the Main Base unit near the DC
(fig 3)		power jack (Fig 4). Hold the Registration button in until a long beep confirms the handset has

The Registration process needs to be completed within 15 seconds, 3 beep tones will indicate that the time has been exceeded. Please start the process again.

After Registration the	Fig 4.
handset number is shown
on the Display screen either					Handset
during a call or while the	Fig 5.	HANDSET:	1	TALK HIGH 1
handset is charging (Fig 5).		NEW:	1		Registration
					number
		TOTAL:	1
					displayed
		Charging		On a Call

14