The handset will remain in “T-coil” mode for all future calls or until the “T-coil” mode is turned off.

To turn off the “T-coil” mode perform the following steps on your handset: While on a call:

) Press and hold [mute] for at least 5 seconds or until a beep tone is heard.

2)The “T-coil” mode icon will no longer appear on the handset LCD display.

Note: Using the T-coil mode may shorten the amount of time you can talk on your handset between battery charges. Therefore it is recommended that the handset be returned to the charging cradle when not in use. If this feature is not required, the “T-coil” mode should not be turned on.

Finding a Lost Handset

To locate a misplaced handset, press [find hs] on the base when the phone is in standby. All registered handsets will beep for 60 seconds, and PAGING appears on the handset display. To cancel paging, press [find hs] on the base.

Note: If the battery pack is completely drained, the handset will not beep when paging.

Using Hold, Conference and Transfer

Placing a Call on Hold

) During a call, press [int’com/hold] on the handset to place the caller on hold. If you leave a caller on hold for more than ten seconds, the display screen will read, LINE ON HOLD.

2)To return to the party on hold, press [/flash] or [] on a handset. The phone will return to the holding party.

Note:

You can only place a caller on hold for 5 minutes. Once 5 minutes has passed, that party’s line will be discon- nected and the phone will return to standby.

While a call is on hold, Caller ID and Call Waiting cannot be received.

40

Page 41
Image 41
Uniden DSS7915+1 owner manual Finding a Lost Handset, Using Hold, Conference and Transfer, Placing a Call on Hold