Uniden DX14560 Series, DX14561 Series guide

Installing the Rechargeable Battery Packs into the Handsets

Installing the Rechargeable Battery Packs into the Handsets

Each handset is powered by a rechargeable battery pack. Once installed, the battery charges automatically when the handset is placed in the base or charging cradle.

To install the rechargeable battery pack:

1)Press down on the handset battery case cover (use the finger indention for a better grip) and slide the cover downward to remove.

2)Plug the battery pack connector (red & black wires) into the small jack inside the battery compartment. (The connector notches fit into the grooves of the jack only one-way.) Match the wire colors to the polarity label in the battery compartment, connect the battery, and listen for a click to insure connection.

3)Make sure you have a good connection by slightly pulling on the battery wires. If the connection is secure, the battery jack will remain in place.

4)Place the battery case cover back in the handset by sliding it upwards until it clicks into place.

Note: Use only the Uniden (BT-1006) rechargeable battery pack supplied with your phone.

Image 9

Uniden DX14560 Series, DX14561 Series manual Installing the Rechargeable Battery Packs into the Handsets

Contents

Page Contents Welcome Accessibility Manual Conventions TerminologyBase Charger Product Overview Main Phone Features Handsets Controls and Functions Extra Charging Cradle Main Base Unitfind key TEL LINE jack Choosing the Best Location Installing the Phone Installing the Rechargeable Battery Packs into the Handsets Installing the Base Unit and Charging Cradle Modular Standard wall plate mounting Mounting the Base Unit on a Wall Direct wall mounting The charging cradle can be used to charge any handset Register Handsets to the Main Base before Using When to Re-register Handsets Activating AutoTalk Basic Setup Programming Your Area Code Activating Caller ID on Call Waiting HS1 only Choosing the Dialing Mode HS1 only Setting the Language Storing a Name and Number in Memory Using the Speed Dial Memory The name can be up to 13 characters If you make a mistake while entering a name Storing Caller ID in Speed Dial Memory Using Your Phone Making and Receiving CallsMaking a Call from Speed Dial Memory Making a Call from the Caller ID List To cancel speed dialing Transferring a Call To transfer a callTo receive a transfer call Adjusting the Earpiece Volume Selecting the Ring Tone and VolumeRedialing the Last Dialed Number Temporarily Mute Ringer Using Call Waiting Selecting a Different ChannelFind Handset Tone Dialing Switch-over Voice Mail Waiting IndicatorTo access your voice mailbox Caller ID and CIDCW Caller ID on Call Waiting Viewing the Caller ID Message List Caller ID on Call Waiting CIDCW Deleting Information from the Caller ID List Deleting a Caller ID messageDeleting all Caller ID names/numbers Changing the Digital Security Code Maintenance SpecificationsPower Failure Talk and Standby Times Low battery alert Cleaning the battery charging contacts Battery replacement and handling Troubleshooting Common IssuesTraveling Out-of-Range Suggestion Symptom Suggestion Liquid Damage Rechargeable Nickel-Cadmium Battery Warning PrecautionsRechargeable Nickel-Cadmium Batteries Must Be Recycled or Disposed of Properly Important Safety Instructions SAVE THESE INSTRUCTIONSThe FCC Wants You To Know Radio Interference Cordless Telephone Privacy I.C. NoticeTerminal Equipment Radio Equipment One Year Limited Warranty E, F, G, H IndexI, J, K, L M, N, O, P, Q At Uniden, we’ll take care of you