Symptom | Suggestion |
|
|
The caller ID does not | • The handset was picked up before |
display | the second ring. |
| • The call was placed through a switch |
| board. |
| • Call your local telephone company |
| to verify your Caller ID service is |
| current. |
|
|
The answering system | • Make sure the base unit is plugged |
does not work. | in. |
| • Make sure that the answering system |
| is turned on. |
| • Make sure that the message record |
| time is not set to ANN (See page 41). |
|
|
Messages are | • The incoming messages may be too |
incomplete. | long. Remind callers to leave a |
| brief message. |
| • The memory may be full. Delete |
| some or all of the saved messages. |
|
|
The outgoing message | • Record your greeting again. |
is deleted. | The preset messages should remain. |
|
|
No sounds on the base | • Adjust the speaker volume on the |
unit speaker during call | base unit. |
monitoring or message |
|
playback. |
|
|
|
Cannot access remote | • Make sure you are using the correct |
PIN number. | |
another | • Make sure that the |
phone. | you're using can transmit the tone. If |
| it cannnot, you may have to use |
| another phone to access your |
| message. |
|
|
52
