Uniden EXT1165, EXT1160 D. Choose the dialing mode, If your dialing system is, Set the switch to

•After installing the battery pack in the handset, charge your handset at least 15-20 hours before plugging into the phone line. Once the handset battery pack is fully charged, connect the telephone line cord to the base and telephone wall outlet.

5)Connect the telephone line cord to the TEL LINE jack and to a telephone outlet once the handset is fully charged.

If your telephone outlet isn't modular, contact your telephone company for

assistance.Modular

D. Choose the dialing mode

Most phone systems use tone dialing which sends DTMF tones through the phone lines. However some phone systems still use pulse dialing such as in rural areas. The default setting is tone dialing. Depending on your dialing system, set the mode as follows:

If your dialing system is	Set the switch to
Tone	TONE
Pulse	PULSE

PULSE -TONE DC IN 9V TEL LINE

•If you are not sure of your dialing system, set for tone dialing. Make a trial call. If the call connects, leave the setting as is, otherwise set for pulse dialing.

•If your phone system requires pulse dialing and you need to send the DTMF tones for certain situations during a call, you may "switch-over" to tone dialing. (Refer to "Tone Dialing Switch-over" on page 15.)

[ 10 ] G E T T I N G S TA R T E D