With the base

While using the base speakerphone, press mute on the base to mute the microphone. Mute On and appear in the display. To cancel muting, press mute again or press speaker. Mute Off appears.

Tone Dialing Switch-over

If your telephone company requires pulse dialing, you can switch-over to tone dialing after the call connects. This feature is useful when you need tone dialing to use any automated menu systems, such as telephone bank tellers, telephone prescription refills, customer support menus, etc.

If your phone is set to pulse dialing mode, make your call normally. Once your call connects, press the */tone/< key. Any digits you enter from then on will be sent as tone digits. When this particular call ends, the phone automatically returns to pulse dialing mode.

Traveling Out of Range

During a call, as you begin to move your handset too far from your base unit, noise may increase. If you pass the range limits of the base unit, you will hear a beep and see Out of Range on the display, and then the handset returns to standby mode.

note

•The tone feature only applies when the dial mode is set to pulse.

•This special number can be stored in a memory location. This is referred to as Chain Dialing (see page 41).

B A S I C S

w w w . u n i d e n . c o m

B A S I C S [ 3 6 ]

Page 37
Image 37
Uniden TRU 8065, TRU8865 owner manual Tone Dialing Switch-over, Traveling Out of Range, With the base