Preparing the Battery Pack
Charge the battery pack for at least 15 hours before you start using your phone.
1 Press in on the battery cover release and slide the cover down until it comes off.
2 Connect the battery pack connector with the correct polarity (black and red wires), then insert the battery pack into the battery compartment.
3 Securely close the battery compartment cover by sliding it up until it snaps into place.
4 Place the handset on the base as shown.
4, 5
5 Make sure that the status LED lights. If the LED doesn´t light, check to see that the AC adapter is plugged in and that the handset makes good contact with the base charging contacts.
Use only the Uniden Battery |
| |
with your phone. Replacement batteries are also | status LED | |
available through the Uniden Parts Department. | ||
| ||
(see page 5) |
|
G E T T I N G S TA R T E D [9 ]
G E T T I N G S TA R T E D
