Uniden UBC785XLT manual Restoring a Locked-out Channel, Restoring All Locked-out Channels

Lockout in Scanning Mode

If the scanner keeps stopping on a particular channel due to noise or frequent transmissions, you may want to keep that channel from scanning.

1.Wait until the scanner stops on the channel.

2.Then press L/O.

3.The scanner immediately resumes scanning because the locked out channel is no longer in the scanning sequence.

Lockout Tips	Write down your locked-out channels and put in a convenient place in
	case you need to restore them.

Restoring a Locked-out Channel

1.Press ▲/HOLD.

2.Select a locked out channel by using the keypad, then press ▲/HOLD.

3.Press L/O. The L/O disappears.

Restoring All Locked-out Channels

You can restore all locked-out channels in a bank only when a bank is selected for scan. If you have deselected a bank and you want to restore all of its locked-out channels using the steps below, you must press SCAN and then enter the number of the bank on your keypad.

1. Press ▲/HOLD.

Note: You must be in Hold mode before restoring all locked-out channels.

2.Press and hold L/O for about 2 seconds.

You will hear two beeps when all the channels have been restored.

31