Setting Up a Scan
You can have the receiver automatically cycle through the enabled channels.
1.Open the menu, and scroll down to select Scan time.
2.Use Right or Left to select the amount of time you want the receiver to stay on each camera. Choose 5 seconds, 10 seconds, 15 seconds, or 20 seconds. To turn off the scan and stay on the current channel, select Off. To set the receiver into quad display, select Quad (see Using Quad Display on page 16).
3.
►The receiver stays on each camera channel for the selected number of seconds, then switches to the next active channel.
►The receiver starts the scan at the currently selected channel, then scans the remaining channels in order.
►The receiver will only scan channels that are enabled in the menu.
►The receiver does not go into quad display during a scan.
►If you press 
to manually switch channels, the receiver turns off the scan. Follow the procedure above to turn it back on.
If... | Try... | |
The display says No Signal | - Making sure there is a camera assigned the channel. | |
when the receiver switches to a | - Making sure the camera is in range of the receiver. | |
particular channel. | - Troubleshoot the camera assigned to that channel. | |
|
| |
The receiver won’t switch to a | - Making sure the channel is enabled (set to On in the | |
particular channel. | menu). | |
The receiver won’t scan | - Making sure Scan Time is not set to Off or Quad. | |
channels. | - Making sure more than one channel is enabled. | |
|
| |
I can’t switch channels manually. | - Making sure more than one channel is enabled. | |
- Making sure you are not in quad display. | ||
| ||
|
|
15
