Uniden UIP1868P quick start Setting up with Dhcp, Setting up with PPPoE

Figure #1

Figure #2

1Setting up with DHCP

The UIP1868P is configured for use with Dynamic Host Configuration Protocol (DHCP) by default. If your broadband connection uses DHCP, simply connect your broadband modem to the WAN port of the phone and then connect the phone’s power cord to an AC power outlet.

2Setting up with PPPoE

If your broadband connection uses PPPoE, you will need to configure the UIP1868P built-in router by inputting the user name and password provided by your Internet Service Provider. Follow the steps below to configure the UIP1868P to use a PPPoE-based connection.

a)Connect a computer with a web browser

directly to the LAN port of your UIP1868P.

b)Type http://192.168.15.1 (the default IP address of your UIP1868P) into the address bar of your web browser. Then press the Enter key. (See Figure #1)

c) You should now see your UIP1868P’s System Information Screen. (See Figure #2)

d)In the menu bar down the left side of the screen, select WAN.

e)In the menu bar on the top of the screen, select PPPoE. This opens the WAN PPPoE Configuration screen.

(See Figure #3)

Figure #3