General Operating Instructions
If an automatic oiler is not used, add a few drops of Pneumatic Tool Oil to the airline connection before use. Add a few drops more after each hour of continual use.
IMPORTANT: Before each use, test the Shear on scrap material of the same weight and hardness as the workpiece.
1.Mark the cutting line on the workpiece.
2.Hold the Shear with both hands safely away from Blades.
3.Position the Shear so that the Center Blade is below, and the Left and Right Blades are above, the edge of the workpiece.
4.Squeeze and hold the Trigger and allow the Blades to reach full speed.
5.Guide the Blades along the marked line of the workpiece.
6.If the tool requires more force to accomplish the task, verify that the tool receives sufficient, unobstructed airflow (CFM) and increase the pressure (PSI) output of the regulator up to the maximum air pressure rating of this tool.
CAUTION! To prevent injury from tool or accessory failure:
Do not exceed the tool's maximum air pressure rating.
If the tool still does not have sufficient force at maximum pressure and sufficient airflow, then a larger tool may be required.
7.When finished, to prevent accidents, turn off the tool, detach the air supply, safely discharge any residual air pressure in the tool, and release the throttle and/or turn the switch to its off position after use. Clean external surfaces of the tool with clean, dry cloth, and apply a thin coat of tool oil. Then store the tool indoors out of children's reach.
Safety
Setup
Operation
Maintenance
Item 98580 | For technical questions, please call | Page 11 |
