HOT AIR
PLENUM
| 7/8" HOLE | |
6" (15.24cm) | ||
(8.9 cm) | ||
|
SIDE OF HOTBLAST FURNACE
Drill one 7/8" hole as illustrated for placement of the Hotblast fan limit control.
FAN LIMIT
CONTROL ON
PLENUM
COMBUSTION AIR
All fires need air (specifically oxygen) to burn. Furnaces, fire- places, and
ASSEMBLY INSTRUCTIONS
Your furnace is shipped from the factory in four (3) packages.
1)the furnace, 2) fan limit kit, 3) draft kit. Before assembling the furnace, check to make sure there is no shipping damage, and that all necessary parts are located in the firebox. See parts list below.
If you find shipping damage or any of the parts missing, contact the dealer immediately. He will take the necessary steps to correct the problem.
Parts List
All models include the following: |
|
Two Door Handles | FAN LIMIT KIT |
One Fuel Door Latch | Fan Limit Control |
One Ash Door Latch | Fan Center |
One Shaker Grate Handle | F.A.D. Box |
Two 1/2" Washers | |
Six 1/4" Hex Nuts | Knob |
Four Lock Washers |
|
Spin Draft |
|
Five 1/4" Lock Nuts |
|
One Pivot Bracket |
|
Four Brass Coil Knobs |
|
One 1/4" x 1" Hex Bolt |
|
Three |
|
One 1/2" x 2 1/2" Carriage Bolt |
|
Six 1/4" x 3/4" Hex Bolts |
|
Smoke Door |
|
Two 1/4" x |
|
Two Smoke Door Clips |
|
Rod Extension |
|
DOOR HANDLE INSTALLATION
Insert door handle into door. From rear side of door place 1/2" washer over threaded part of door handle. Then attach 1/2" lock nut, being careful not to over tighten. Handle should turn freely.
FUEL & ASH DOOR LATCH INSTALLATION
With two 1/4" x 3/4" hex bolts, attach the door latch to the door latch mounting bracket on the left side of door frame as illustrated. Adjust latch until door closes securely.
FUEL DOOR
ILLUSTRATION
ASH DOOR
ILLUSTRATION
LOCK
WASHER
HEX
NUTS
7