INSTALLATION OF OPTIONAL EQUIPMENT
INSTALLING DOMESTIC HOT WATER COIL
1.Remove access panel at rear of enclosure.
2.With a utility knife cut out the section of fiberglass insulation directly behind the access panel.
3.Remove cover plate from rear of firebox.
4.Place one nut on each end of the coil and thread each as far as they will go.
5.Place the coil through the holes from the inside of the firebox and run a washer and nut down each leg on the outside of the stove. Before tightening the nuts down completely, wrap a piece of
6.Remove knockouts from access panel and attach to furnace enclosure.
7.Have a qualified plumber connect your domestic hot water pipe to the coil with appropriate fittings.
ACCESS
PANEL
1
4
REAR WALL OF FIREBOX
5
DOMESTIC HOT
WATER COIL
1. NUT | TURN INSIDE NUTS UP |
TO END OF THREADS |
2.WASHER
3.GASKET
2
3
6
19