Toro 5020, 2020, 3020 Fenders SP, Left FenderSeat Base Removal Fig, Seat Base Installation Fig

Fenders (SP 5020)

Left Fender(Seat Base )Removal (Fig. 44)

1

1.Park machine on a level surface, lower attachment, stop engine, engage parking brake, and remove key from the ignition switch.

2.	Pivot seat up. Separate seat rod from the base by	3
removing cotter pin and flat washer.
3.	Separate base from frame by removing both lock	4
nuts, cap screws, flat washers, and spacers.		2
Seat Base Installation (Fig. 44)

1.Position seat base to the frame. Secure base to frame with both spacers, flat washers, and lock nuts.

2.Secure seat rod to the seat base with flat washer and cotter pin. Pivot seat down.

Right Fender Removal (Fig. 25 and 26)

1.Park machine on a level surface, lower attachment, stop engine, engage parking brake, and remove key from the ignition switch. Pivot seat up.

Figure 24

1.	Cotter pin & flat washer	3.	Lock nut
2.	Seat rod	4.	Cap screw & flat washer

8

7

46

2.Disconnect black (negative) cable from the battery.

3.Remove knobs from throttle and choke controls. Remove cap screws and lock nuts securing controls to the right fender. Pull controls clear of the fender.

4.Remove hex nut and lock washer securing the igni- tion switch to the right fender. Pull switch clear of the fender.

5.Unscrew knob from the lift lever. Remove both hex flange head screws from the fender. Remove both car- riage bolts and lock nuts securing the fender to the rear panel.

	3		2
	1
5
	Figure 25
1.	Knob	5.	Ignition switch
2.	Throttle control	6.	Hex flange head screw
3.	Choke control	7.	Lift lever
4.	Cap screw & lock nut	8.	Carriage bolt & lock nut

6.	Loosen hose clamp and remove hose from air					3
cleaner. Remove cap screw, flat washer, lock nut secur-
ing the right fender to the frame. Remove fender.
Right Fender Installation (Fig. 25 and 26)					2
						1
1.	Position right fender to the frame. Secure fender to
frame with hex flange head screws. Secure fender to
rear panel with both carriage bolts and lock nuts.
2.	Secure fender to frame with cap screw, flat washer,			4
and lock nut. Secure hose to cleaner with hose clamp.
3.	Secure ignition switch to the fender with lock washer				Figure 26
			1.	Hose clamp	3.	Cap screw/flat washer
and hex nut.
			2.	Air cleaner hose	4.	Right fender
4.	Secure choke and throttle controls to the fender with		5. Connect black (negative) cable to the battery.
cap screws and lock nuts. Install knobs to both controls.
Wheels, Brakes, and Miscellaneous		Page 6 – 24			Sand Pro 2020/3020/5020