Toro 5020 Brake Linkages SP 2020/3020, Right, Front, Wheels, Brakes, and Miscellaneous, Page 6

Brake Linkages (SP 2020/3020)

	1		3
	5		4
			2
			7
			6
			8
			9
			10
			11
		7
	RIGHT				19	20
		12
					8
	FRONT	13
			14		9
					18
			15
				7		21
			16		17
1.	Cap screw	8.	Figure 10			15.	Side flange bearing
			Clevis
2.	Lock nut	9.	Jam nut			16.	Cap screw
3.	Brake lever	10. Brake rod				17.	Brake arm
4.	Spacer	11. Adjusting rod				18.	Adjusting rod
5.	Clevis pin	12. Roll pins				19.	Cotter pin
6.	Flat washer	13. Spacer				20.	Brake lever (to brake assembly)
7.	Cotter pin	14. Flat washer				21.	Clevis pin

Most parking brake linkage parts can be repaired or re- placed without removing any interference. However, the lift valve shroud must be removed to work on the parking brake lever.

CAUTION

The muffler and exhaust pipe may be hot. Avoid possible burns; allow engine and exhaust sys- tem to cool before working near muffler.

1

4

3

2

5

1.Remove knob from the lift lever. Remove both lock nuts and cap screws securing the lift valve shroud, lift le- ver guide, and lift lever latch (Fig. 26).

2.Remove bottom front cap screw securing the lift valve shroud to the frame. Pull shroud from the frame (Fig. 26).

IMPORTANT:When removing the clevis from either the brake rod or brake lever or the brake lever from the cam shaft on the brake assembly, make sure to matchmark both parts. Marking both parts will make reassembly and brake adjustment easier.

Figure 11

1.	Knob	4.	Lift lever guide & latch
2.	Lock nut & cap screw	5.	Cap screw

3.Lift valve shroud

3.Remove and replace parts as necessary to repair brake linkages (Fig. 10).

4.Reinstall lift lever latch, lift lever guide, lift valve shroud, and knob (Fig. 26).

IMPORTANT:Always check and adjust the brakes anytime brake linkages are disassembled or re- paired (see Brake Adjustment).

Wheels, Brakes, and Miscellaneous Page 6 – 12 Sand Pro 2020/3020/5020