Toro 2020, 5020, 3020 service manual Engine

3.Tighten both set screws on the engine hub to secure hub to the engine shaft (Fig. 46).

4.Connect throttle control cable to the swivel and choke control cable to the choke lever (see Throttle and Choke Control Installation).

5.Connect wire harness as follows (Fig. 45):

A.Connect blue wire to the magneto terminal.

B.Connect blue wire with fusible link to voltage reg- ulator.

C.Connect red/white wire to fuel solenoid.

6.Install seat base with seat attached to the frame as follows (Fig. 44):

A.Position base on machine. Secure base to frame with both spacers, cap screws, flat washers, and lock nuts.

B.Secure seat rod to the base with flat washer and cotter pin.

7.Install and connect battery to the machine (see Bat- tery Service in Chapter 5 – Electrical Systems).

8.Secure fuel hose to the fuel pump with hose clamp. Remove clamp from fuel hose that was used to prevent fuel spillage. Open fuel shutoff valve.

Engine

Sand Pro 2020/3020/5020 Page 3 – 29 Engine