Toro 5020, 2020, 3020 service manual Throttle and Choke Controls, Throttle Control Removal

Throttle and Choke Controls

1

						6
	4		9	4	4
					2
	3					2
		8	5	1		1
		7
	2
				Figure 10
1.	Knob		4.	Cap screw	7.	Hex nut
2.	Throttle control		5.	Dash Panel (SP 2020/3020)	8.	Lock Washer
3.	Lock nut		6.	Right fender (SP 5020)	9.	Choke control

Throttle Control Removal

1.Park machine on a level surface, lower attachment, stop engine, engage parking brake, and remove key from the ignition switch.

2.Pivot seat up. On the SP 2020/3020, remove the en- gine shield.

3.On the SP 2020/3020 remove three hex flange head screws securing the hood to the front shield (Fig. 11). Remove four cap screws securing the dash panel to the hood (Fig. 12). Remove hood from the machine.

4.Release throttle cable from clamp securing it to the engine. Disconnect throttle cable from the swivel on the engine (Fig. 13).

5.Remove throttle knob from the throttle control. Re- move both lock nuts and cap screws securing the throttle control to the dash panel or right fender. Remove throttle control from the machine (Fig. 10).

1

2

3

Figure 11

1.	Hex flange head screw	3. Front shield
2.	Hood

3

1

2

1

		Figure 12
1.	Cap screws	3. Hood
2.	Dash panel

Engine Page 3 – 10 Sand Pro 2020/3020/5020