Jacking Instructions
CAUTION
When changing attachments, tires, or per- forming other service, use correct blocks, hoists, and jacks. Make sure machine is parked on a solid level floor such as a concrete floor. Prior to raising the machine, remove any attachments that may interfere with the safe and proper raising of the machine. Always chock or block wheels. Used jack stands or solid wood blocks to support the raised ma- chine. If the machine is not properly supported by blocks or jack stands, the machine may move or fall, which may result in personal inju- ry.
Use the following positions when jacking up the ma- chine:
Jacking the Front End
1.On the SP 2020/3020, jack from below the front cross support that is above the retaining strip for the rub- ber shield (Fig. 1).
2.On the SP 5020, jack from below the front cross support tube on the bottom of the frame (Fig. 2).
Jacking the Rear End
1.On the SP 2020/3020, jack from below the square tube of the frame (Fig. 3).
2.On the SP 5020, jack from below the square tube of the frame (Fig. 3).
Figure 1
Figure 2
Figure 3
|
| Figure 4 |
Safety | Page 1 – 4 | Sand Pro 2020/3020/5020 |
