Toro service manual Fuel Tank installation Fig, Engine, Sand Pro 2020/3020/5020, Page 3

3.Remove adjustment lever from tilt lock pin by first re- moving cap screw (Fig. 36).

4.Drain fuel tank as follows:

A.Close fuel shutoff valve.

B.Remove self tapping screw securing the fuel hose and R–clamp to the frame.

C.Disconnect fuel hose leading from the fuel tank at the fuel shutoff valve. Use funnel and hose to drain the fuel into a suitable container for storage.

5.Remove four cap screws and flat washers securing the fuel tank to the frame.

6.Make sure not to tear the steering boot while care- fully pulling the top of the boot over the tilt pin.

7.Lift fuel tank from frame. Make sure not to lose grommets.

Fuel Tank installation (Fig. 34)

1.Position fuel tank to the frame making sure not to tear the steering boot while carefully lowering the top of the boot over the tilt pin.

A.Apply antiseize lubricant to the threads of the four cap screws.

B.Make sure grommets are in place. Secure fuel tank to the fame with four flat washers and cap screws.

C.Torque cap screws from 30 to 60 in–lb (35 to 69 kg–cm).

2.Route fuel hose from the tank to the fuel shutoff valve. Connect and secure fuel hose to the shutoff valve with the hose clamp.

3.Secure R–clamp and fuel hose to the frame with self tapping screw.

4.Secure adjustment lever to tilt lock pin with cap screw (Fig. 36).

5.Install steering wheel onto the upper steering shaft. Secure steering wheel to upper steering shaft with the roll pin using a drift punch (Fig. 35).

6.Open fuel shutoff valve.

7.Fill fuel tank with fuel (see Fill fuel Tank). Check fuel lines and tank for leaks.

3

41

2

Figure 36

1.	Adjustment lever	3.	Cap screw
2.	Tilt lock pin	4.	Steering boot

Engine

Sand Pro 2020/3020/5020 Page 3 – 21 Engine